3.5 inch TFT LCD Touch Screen Module SPI RGB Display For Raspberry Pi 3 2 B+ pi2

TFT features: 1.LCD Type : TFT Transmissive --- 2.interface : spi(32MHZ) 3.Number of Dots : 320*(RGB)*480 Dots 4.size : 86.0*56.2mm 5.Approx. Weight : TBD g 6.Back Light : 6 White LED 7.Touch chip : xpt2046 Interface Define: 24--GPIO7 --------> TP_CS 26--GPIO8 --------> LCD_CS 22--GPIO25 --------> TP_irq 23--GPIO11 --------> SPI_CLK 21--GPIO9 ---------> SPI_MISO 19--GPIO10 ---------> SPI_MOSI 5v ---------> 5v GND ---------> GND HOW TO USE?(2 methods) 1.You can burn the image file to SD card . 2.Installation drive: The LCD screen and raspberry pie development board connected correctly copy the drive (LCD_show.tar.gz) to raspberry pi; Decompression file tar -xzvf LCD_show.tar.gz Jump into the file cd LCD-show Update system sudo apt-get update Install driver sudo ./LCD35_v1 After a few seconds ,the system will reboot if you want to use the HDMI ,you can use this cmd sudo ./LCD_hdmi Note: you must use this command sudo apt-mark hold raspberrypi-bootloader before you update your system. Then use the command, sudo apt-get update sudo apt-get upgrade Otherwise it will fail after the restart Note: other pins are NC;